Peugeot 308 Key Fob Replacement
Peugeot's 308 could be catching on a little, but it still feels appealing. It's not the most luxurious car in its class, but it is a pleasant and peaceful drive.
We often get asked at Coded Car Keys to replace peugeot key fobs. These tips can aid in solving the issue whether it is constant or intermittent.
Water Damage
If you accidentally drop your key fob in an eddy, or it gets wet while kayaking, canoeing, rafting, or canyoning the fob is most likely to be damaged by water. The best way to avoid this from happening is to keep it in a dry bag when you're out in the open or engaging in activities where the fob could be exposed to a lot of water.
It's also crucial to ensure sure that the fob is completely dried out prior to opening it to use it again. If you notice any odors coming from the fob, such as an industrial-type smell or a sour taste like windshield washer fluid, it's another indication that it's been submerged in water.
A circuit board that's wet can cause the battery's charge to drop its charge or even explode. If you can pull the 308 keyfob from the water it is best to turn the button side up and shake as much water as you can prior to opening the casing. Remove the battery, then wipe the circuit board down using a cotton swab which has been dipped into 90-percent alcohol.
Other reasons why your Peugeot 308 remote keyless entry system that you use to enter your home may stop working include an empty coin battery problems with the receiver module, signal interference, or a faulty electronic chip. If none of these causes the issue, try resetting the system by removing the battery with 12 volts for around 15 minutes.
Dead Coin Battery
Peugeot cars come with remote start that allows drivers to start their car from an extended distance, which allows them to warm up or cool down the vehicle before they get in. This feature is extremely useful particularly during the winter's cold and chilly months. But sometimes, the remote start system stops working due to a variety of reasons, like the battery in the coin is dead.
The coin-shaped battery located inside the key fob will last between two and four years depending on how often it is utilized, the place it was purchased and how it is utilized. The date of use is usually printed on the packaging or listed in the instruction manual.
If the key fob is not functioning after exposure to water that is clean and you want to remove the battery, clean the electronic chip with a paper towel and isopropyl alcohol, then dry it thoroughly before replacing it. If the key fob was exposed to soapy or salty water, it could have caused the chip to be damaged. You will need to replace it.
If you're unsure whether the battery is damaged it is possible to check its voltage using an instrument connected to the terminals for plus and minus. If the voltage is lower than 12-13 volts, then it is time to replace the battery. You can also reset your computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should now begin.
Faulty Receiver Module
If you don't get the "Key Detected", it could be the receiver module malfunctioning. It is the part that sends out a signal when your key fob turns on. It also functions as an alarm and prevents the car from starting if you don't have the correct key.
This could result from a variety of factors including water damage or simply the aging process. If the electronic chip in your Peugeot 308 keyfob is damaged due to dirty tap water It could be because the keyfob was in contact with it. In this case you'll have to take it apart and clean it thoroughly using isopropyl alcohol, or electronic cleaner. When the battery is clean you can try it again.
If the issue isn't resolved then it's a good option to consult an area Peugeot specialist or locksmith. They'll be able to make use of a diagnostic device to assist in identifying the problem and repair it for you.
The loss of your Peugeot keys to your car is an emotional experience. However, a professional auto locksmith can fix the issue in a matter of minutes. They can program your car and cut a fresh, functioning key for you. Click here to find a locksmith near you.
Faulty Electronic Chip
The chip in the Peugeot 308 key fob plays an essential function in the remote control system. If the chip is damaged, you could be unable to start your car or get a message saying "anti-theft". If this occurs, the only solution to fix the issue is to obtain a new key. Auto locksmiths who are professionals can provide this service in the shortest time.
The chip in your Peugeot 308's key fob could fail due to many reasons, including sweat, water damage, or dirt. If your Peugeot 308 key fob has been exposed to soapy water, you should take it to the cleaners immediately. TheKeyLab can use a paper towel and isopropyl alcohol to wipe the electronic component. The battery must then be allowed to fully dry.
Sometimes keys can not function due to radio interference. This is usually caused by other devices use the same frequency as your Peugeot keyfob. It can also be caused by weather conditions or objects around the vehicle. It is recommended to visit a Peugeot dealer if you encounter this issue.
The Peugeot Key Fob 207/308 is fragile and requires special care. It should not be dropped or throw it around. If you lose it, try to locate it as quickly as is possible. You can reset the onboard computer by disconnecting the battery for a couple of minutes. Make sure you disconnect the negative cable first, and then the positive.